Electromagnetic radiation with a wavelength of 445 nm appears as blue light to the human eye. the energy of one photon of this light is ________ j.

Answer:

Sample Response: No, the resulting wave in the diagram does not demonstrate destructive interference. The resulting wave in the diagram shows a bigger wave than Wave 1 or Wave 2. If it demonstrated destructive interference, it would be a smaller wave or a horizontal line. With destructive interference, waves break down to form a smaller wave, or cancel each other out, resulting in no wave formation.

The final temperature of the mixture is 48.33° C.

The term "temperature" describes how hot or cold a body is. It is, specifically, a method of calculating the kinetic energy of the particles that make up an item. When particles move more quickly, the temperature rises, and vice versa.

Given parameters:

Volume of the water at 25.00° C, V₁ = 240.0 mL.

Volume of the water at 95.00° C, V₂ = 120.0 mL.

The density of water, ρ = 1.00 g/mL

Then, final temperature, t = ?

Mass of the water at 25.00° C, m₁ = V₁ρ = 240.0× 1 g = 240.0 g.

Mass of the water at 95.00° C, m₁ = V₁ρ = 120.0× 1 g = 120.0 g.

We know that, specific heat of water, s =1 CGS unit.

Then, the amount of heat energy absorbed by the water at 25.00° C to reach final temperature (t), is H₁ = m₁s(t-25) Joule =240(t-25) Joule.

And the amount of heat energy dissipated by the water at 95.00° C to reach final temperature (t), is H₂ = m₂s(95 - t) Joule = 120 (95 - t) Joule.

From the conservation of heat energy,

H₁ = H₂

⇒ 240(t-25) = 120 (95 - t)

⇒ 2(t -25) =(95 -t)

⇒ 3t = 95 + 2×25 = 145

⇒ t = 48.33

Hence, the final temperature of the mixture = 48.33° C.

Learn more about temperature here:

https://brainly.com/question/11464844

#SPJ5

Explanation:

While driving on the road we should be alert and cautious at every point of driving. We should also follow the basic traffic rules for ours as well as others safety.  So when passing by a large truck, we should make sure that we see a lot of the pavement area in front of the truck so that we are aware of the fact that there is enough space in front of the truck for us to apply brake and halt our car incase if there is any danger ahead. And also if the truck happens to stop suddenly, we get enough space to stop for our safety. Also to see if there is any obstacles ahead so that we do not hit the obstacle and meet with accidents.  

Final answer:

The distance below the top of the well is 806.4 meters. When taking into account the time for sound to travel up the well, the distance is 0 meters.

Explanation:

(a) To calculate the distance to the water, we can use the formula:

Distance = Speed of Sound x Time

Distance = 336 m/s x 2.40 s

Distance = 806.4 m

(b) To calculate the distance taking into account the time for sound to travel up the well, we subtract the time for sound to travel up:

Distance = (Speed of Sound x Time) - Speed of Sound x Time for Sound to Travel Up

Distance = 336 m/s x 2.40 s - 336 m/s x 2.40 s

Distance = 0 m

Answer:Explained

Explanation:

Before Passing the another vehicle

Before passing another vehicle, the first major step is to ensure proper signaling and check blind spots. Signaling is crucial as it communicates your intention to the drivers behind and ahead of you.

Activating the turn signal in the direction you plan to pass alerts others of your intentions. Checking blind spots is equally important to ensure there are no vehicles present in the adjacent lanes that may be hidden from your mirrors.

This step involves a quick glance over your shoulder to verify that the lane is clear and safe for passing. Only after completing these steps should you proceed with passing the vehicle.

To know more about communicates :

https://brainly.com/question/31309145

#SPJ6.

Only the vertical height of the stairs is used to calculate work related to gravitational potential energy because work done by gravity is only dependent on vertical displacement. The formula W = mgh is used, where h is the vertical height, which directly increases the gravitational potential energy when climbing stairs.

The reason why only the vertical height of the stairs is measured when calculating work related to an increase in gravitational potential energy (GPE) is that work done by gravity depends only on the vertical displacement in the gravitational field. In the context of climbing stairs, the person does work against the gravitational force to increase their GPE, which is calculated as mgh, where m is mass, g is the acceleration due to gravity, and h is the vertical height. The work going into mechanical energy is given by W = KE + PE. Initially, at the bottom of the stairs, both kinetic energy (KE) and GPE are zero. As a person climbs the stairs, the GPE increases while KE remains unchanged if they climb at a constant speed, making the GPE the significant term in the work-energy equation (W = mgh). We can then calculate work and divide it by time to determine the power output.

Tensile force refers to the stretching force experienced when forces pull on both ends of a material like wire. Equal and opposite forces lead to tension that is equally distributed across the material, as seen in Figure 5.24. The example of a tightrope walker underscores that most of the tension resides in the wire itself rather than supporting the walker's weight.

In Physics, the term tensile force is used to describe the stretching force a material experiences when forces are applied on opposing sides, such as a wire being pulled on both ends. In your case, the brass wire has to withstand a tensile force of 350N without breaking.

Considering the principles behind tensile force, the concept of equal and opposing forces holds significant value as depicted in Figure 5.24. This is due to Newton's third law which states that every action has an equal and opposite reaction, ensuring that the tension in the wire is equal throughout. If the tension at one spot in the brass wire could handle 350N, this could be applied across the entire wire.

The tightrope example illustrates a situation where the tensile force is employed. However, not all this tension is used to support the weight of the tightrope walker as the horizontal components are in opposite directions and cancel out. Hence, most of the tension resides in the wire itself.

https://brainly.com/question/25748369

#SPJ12

Answer: from 21 km/h to 31 km/h

Explanation: The more speed it has the more kinetic energy it is required for it to go faster.

Answer:

Whether or not you actually exercise each week is greatly influence by your mindset.

Explanation:

Mindset refers to the way you organize your thoughts and decide to face everyday situations. The way you reflect on a particular situation, and especially how you choose to act upon that personal analysis, can determine your success or failure. So if you can work out each week without fail, it is a big influence by your mindset.

The longest wavelength of light in the visible spectrum has the color Red, while the shortest wavelength of light in the visible spectrum has the color Violet.

Electromagnetic spectrum is nothing but the range of wavelengths or frequencies on which electromagnetic radiation extend. it is whole distribution of electromagnetic waves according to frequency or wavelength. Electromagnetic wave is nothing but a photon which carries energy. Photon has frequency, wavelength as well as amplitude. Electromagnetic spectrum is show in figure.

Range from 4000 angstrom to 7000 angstrom from violet to red respectively shows the visible light. Infrared light is nothing but the heat we feel from the sun. and ultraviolet light is blacked by ozone layer. we can calculate exact value of temperature of the sun rom Stephan's forth power law.

Hence longest wavelength is red and shortest wavelength is violet in the visible spectrum of electromagnetic wave.  

To know more about visible spectrum :

https://brainly.com/question/18704022

#SPJ7.

Low sun angles spread sunlight over a larger area and through more of Earth's atmosphere, reducing its intensity. The Rosetta spacecraft observed this effect, receiving only 4% of the sunlight intensity experienced on Earth. Other phenomena, like solar activity and volcanic activity, can also impact solar energy on Earth's surface.

Low sun angles result in reduced solar energy due to a fundamental physics principle: the intensity of sunlight is spread over a larger area when it strikes the Earth at a more oblique angle. This occurs, for example, during winter when the Sun is low in the sky. As depicted in Figure 4.6, the Sun's rays spread out over a much wider area, becoming less effective at heating the ground. Moreover, when the sun is low in the sky, the sunlight must travel through more of the Earth's atmosphere, which can scatter the light, reducing the intensity of the sunlight that reaches the ground.

Another point to consider is the observed phenomenon reported by the Rosetta spacecraft at 800 million kilometres from the sun. Rosetta’s solar cells had to be specifically designed to function in these cold, low-light conditions as it receives only 4 percent of the light strength received on Earth.

However, while this explains the reduction in the intensity of solar energy at low angles, it's important to note that other phenomena, such as solar activity and volcanic aerosols, can also affect the global temperatures and solar energy received on Earth's surface.

https://brainly.com/question/4461758

#SPJ6

The kayaker needs to paddle at an angle of 41.81º opposite to the current so that he can travel straight across the harbor, and it will take him 44.73 seconds to cross.

This is a 2-dimensional problem, since the kayaker can move in 2 dimensions over the river. For our study, we will model how does the kayaker move in the direction transversal to the river (meaning across the river), and longitudinal to the river (meaning along the river).

On the first part of this problem, we're asked to compute the direction at which the kayaker needs to paddle so that he moves only transversal to the river flow. Since the river flow has a velocity of 2 meters per second on the longitudinal direction, then the kayaker must have a velocity opposite to the river flow on the longitudinal direction of 2 meters per second.

Since he can paddle with a speed of 3 meters per second, we can make a right triangle (check the attached figure), and through trigonometry find the angle at which he needs to paddle against the river to only move in the transversal direction. Therefor we can write:

[tex]sin(\theta) = \frac{2}{3}[/tex]

Therefor [tex]\theta[/tex] is 41.81 degrees. This means that the kayaker moves across the river with a velocity 2.24 meters per second. With this velocity and the width of the river, we can easily find that the time it will take to cross is 44.73 seconds.

Right triangle, velocity, sine of angle.

In the event of a boat motor catching fire, prioritize personal safety by ensuring lifejackets are worn, cut off the fuel source if possible, and use a fire extinguisher at the fire's base. If necessary, evacuate the boat.

The immediate actions if a boat motor catches fire should be focused on ensuring personal safety and then attempting to extinguish the fire. Firstly, ensure everyone on board is wearing a lifejacket for safety. Secondly, turn off the fuel source if possible to prevent the fire from spreading. Following this, use a fire extinguisher if one is available, aiming it at the base of the fire. Be cautious and prioritize evacuating the boat if the fire becomes uncontrollable.

https://brainly.com/question/34212926

#SPJ12

To solve this problem, we must first assume that the gas acts like an ideal gas so that we can use the ideal gas equation:

 P V = n R T

where P is the pressure, V is the volume, n is the number of moles, R is the universal gas constant and T is the absolute temperature

Assuming that the number of moles is constant, then we can write all the variables in the left side:

P V / T = k            where k is a constant (n times R)

Equating two conditions or two states:

P1 V1 / T1 = P2 V2 / T2

We are given that V2 = 2 V1 therefore

P1 V1 T2 = P2 (2V1) T1

P1 T2 = 2 P2 T1

Additionally we are given that the temperature in Celsius is doubled, however in the formula we use the absolute temperature in Kelvin, therefore:

T1 (K) = T1 + 273.15

T2 (K) = 2T1 + 273.15

and P1 = 12 atm

Substituting:

12 (2T1 + 273.15)  = 2 P2 (T1 + 273.15)

P2 = 6 (2T1 + 273.15) / (T1 + 273.15)

Assuming that a nice spring day in Chicago has a temperature of 15 Celsius, therefore:

P2 = 6 (2*15 + 273.15) / (15 + 273.15)

P2 = 6.312 atm

When the Celsius temperature of a gas in a container doubles, and the gas is transferred to a new container with twice the original volume, the new pressure of the system can be computed using the combined gas law.

This Physics question involves understanding how gas laws work. Given the scenario where the Celsius temperature doubles and the gas is transferred to a container functioning at twice the original volume, several gas laws come into play such as Boyle's law and Charles's law, which relate pressure, volume, and temperature.

Let's look at Charles's law first. It states that volume is proportional to the absolute temperature, assuming constant pressure. From this law, we know that the gas's volume will increase when the temperature doubles. Meanwhile, according to Boyle's law, at constant temperature, the pressure and volume of a gas are inversely proportional. In other words, if you double the volume of the container, the pressure will be halved.

The new pressure will be derived by applying the combined gas law which factors the changes in both temperature and volume. Using Combined Gas law which is (P1V1)/T1 = (P2V2)/T2 where the pressures are in atmospheres, volumes in liters, and temperature in Kelvin, you can solve the new pressure in the system.

https://brainly.com/question/12669509

#SPJ3

Plants do not need light energy during the Calvin Cycle of photosynthesis.

When a plant is entering the calvin cycle of photosynthesis, light energy is not required to proceed. The Calvin cycle, also known as the light-independent reactions, utilizes energy stored during the light-dependent reactions to convert carbon dioxide into glucose.